Home : Pro Series : Bark Limiter : Beepers : Field Series : Sport Series : Vice Breaker : Batteries : Accessories
| I Just Received My Remote Trainer from
Repair and the LED Stays Solid Red |
|
If your system is an XLS, XL or earlier system it is normal for the LED on the transmitter
and collar to stay solid red when plugged into the charger if the system is new or has
been repaired. When the system was repaired the receiver LED was upgraded to the XL
configuration. The LED for the XL series is only red; it is no longer red and green. In
addition the indications for on/off, etc., are slightly different. Double Blink Red = Collar is turned
on
Glows Red Steadily = Collar is
receiving signal from transmitter
Single Long Red Flash = Collar has
been turned off
Rapid Red Blink = Low batteries,
recharge the collar soon. This may occur more quickly in the temperatures near or below
freezing.
Glows Red Steadily While On Charger =
Indicates collar is charging. The light will not flash when the charging cycle is
complete. The collar should always be charged for 14 - 20 hours.
For additional information and a
complete list of changes, read the blue paper that came with your unit, or you can review
your Owner's Guide. If you have any questions regarding the proper operation of your
remote trainer you may contact Customer Service by calling 1-800-456-4343.
<<--- Back to FAQ's |
|
